Filter
Top Products
9
Installing Batteries In Your Remote
Your universal remote control (“remote”) is
configured from the factory to control your
set-top. In addition, you can program your
remote to control most TV and VCR
models, as well as various additional
devices.
Your remote requires two AA batteries
(included). Alkaline batteries are recom-
mended. Use the following procedure to
install the batteries.
CAUTION:
Make sure you correctly align the
positive (+) and negative (-) terminals
on the batteries to the corresponding
terminals in the remote control.
1. Press forward and lift the lever on the
back cover of the remote control. The
battery cover releases, and then you can
pull up the cover to remove it.
T6434
2. Insert and firmly seat two new AA
batteries (alkaline recommended) into
the battery compartment.
T6435
3. Slide the battery cover back onto the
remote control, and snap the cover into
place.
If the light on the remote flashes twice
whenever you press a key, the batteries are
weak and should be replaced.