E-57
Appendix
Specifications
Product type
Model
Video system
Display method
DMD panel
Lens
Projection lamp
Contrast ratio
Video input signal
S-video input signal
Digital input signal
Horizontal resolution
Audio output
Computer RGB input signal
Pixel clock
Vertical frequency
Horizontal frequency
Computer control signal
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption
Operating temperature
Storage temperature
Cabinet
I/R carrier frequency
Laser pointer of remote control
Dimensions (approx.)
Weight (approx.)
Supplied accessories
Replacement parts
Digital Multimedia Projector
XG-NV7XU
PAL/SECAM/NTSC 3.58/NTSC 4.43/DTV 480P/DTV 720P/DTV 1080I
Single panel Digital Micromirror Device™ (DMD™) by Texas Instruments
Panel size:
55
⁄64Љ (21.8 mm), 1 chip XGA DMD
No. of dots: 786,432 dots (1,024 [H] ן 768 [V])
1–1.2ן zoom lens, F2.7–3.0, f ס 35–42 mm
P-VIP lamp, AC 120 W
500:1
RCA Connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω terminated
RCA Connector: AUDIO, 0.5 Vrms more than 22 kΩ (stereo)
4-pin mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated
20-
PIN DIGITAL CONNECTOR (INPUT 2):
TMDS/PanelLink
520 TV lines (video input), 750 TV lines (DTV 720P input, Dot by Dot)
2 W (monaural)
15-
PIN MINI D-SUB CONNECTOR (INPUT 1):
RGB separate/composite sync/sync on green type analog input: 0–0.7 Vp-p, positive,
75 Ω terminated
STEREO MINIJACK: AUDIO, 0.5 Vrms, more than 22 kΩ (stereo)
H
ORIZONTAL SYNC. SIGNAL: TTL level (positive/negative) or composite sync (Apple only)
V
ERTICAL SYNC. SIGNAL: Same as above
12–230 MHz
43–200 Hz
15–126 kHz
9-pin mini-DIN male connector (RS-232C Input Port)
1
37
⁄64Љ ן 1
3
⁄16Љ (4 ן 3 cm) oval
AC 110–120/220–240 V
1.0 A/1.9 A
50/60 Hz
197 W
41°F to 95°F (ם5°C to ם35°C)
14°F to 140°F (מ10°C to ם60°C)
Magnesium alloy (Front panel and rear terminal panel constructed of plastic)
38 kHz
Wave length: 650 nm / Max. output: 1 mW / Class II Laser Product
9
1
⁄4Љ (W) ן 2
9
⁄32Љ (H) ן 12
19
⁄64Љ (D) (235 ן 58 ן 312.5 mm) (main body only)
9
1
⁄4Љ (W) ן 3
15
⁄64Љ (H) ן 12
43
⁄64Љ (D) (235 ן 82 ן 321.8 mm) (including
adjustment feet and projecting parts)
6.28 lbs. (2.85 kg)
Remote control, Two AA size batteries, Power cord (11Ј 10Љ, 3.6 m), Computer cable (9Ј
10Љ, 3 m), Computer audio cable (9Ј 10Љ, 3 m), Mouse control serial cable (3Ј 3Љ, 1 m),
Mouse control cable for IBM PS/2 (3Ј 3Љ, 1 m), Mouse control cable for Mac (6
45
⁄64Љ,
17 cm), DIN-D-sub RS-232C cable (6
45
⁄64Љ, 15 cm), Remote mouse receiver, Carrying bag,
Lens cap (attached), Lens cap strap, CD-ROM, Projector operation manual, Projector
quick reference, Sharp Advanced Presentation Software operation manual, Sharp
Advanced Presentation Software quick reference, IrDA driver installation instruction sheet
Remote control (RRMCG1530CESA), AA size batteries, Power cord (QACCU5013CEZZ),
Computer cable (QCNW-5304CEZZ), Computer audio cable (QCNW-4870CEZZ), Mouse
control serial cable (QCNW-5112CEZZ), Mouse control cable for IBM PS/2 (QCNW-
5113CEZZ), Mouse control cable for Mac (QCNW-5114CEZZ), DIN-D-sub RS-232C cable
(QCNW-5288CEZZ), Remote mouse receiver (RUNTK0661CEZZ), Carrying bag
(GCASN0003CESA), Lens cap (GCOVH1308CESA), Lens cap strap (UBNDT0012CEZZ),
CD-ROM (UDSKA0009CE01), Projector operation manual (TINS-6786CEZZ), Projector
quick reference (TINS-6787CEZZ), Sharp Advanced Presentation Software operation
manual (TINS-6888CEZZ), Sharp Advanced Presentation Software quick reference (TINS-
6788CEZZ), IrDA driver installation instruction sheet (TCAUZ3046CEZZ)
This unit has some inactive pixels within acceptable tolerances which
may result in inactive dots on the picture screen. This will not affect
the picture quality or the life expectancy of the unit.
If you have any questions about this matter, please call toll free 1-800-
BE-SHARP (1-800-237-4277). U.S.A. ONLY
This SHARP projector uses a DMD panel. This very sophisticated
panel contains 786,432 pixels. As with any high technology electronic
equipment such as large screen TVs, video systems and video
cameras, there are certain acceptable tolerances that the equipment
must conform to.
Specifications are subject to change without notice.