Filter
Top Products
20 EN
Getting started
Channel setting (cont’d)
1 2 3
6
54
7
0
8 9
AUDIOREPEAT
PAUSE
SEARCH
SLOW
MENU LISTTOP MENU
STOP
PLAY
FWD
REV
SKIP
PROG.
CLEAR/C-RESET
VCR
REC/OTR
DVD
REC/OTR
PQRS TUV WXYZ
GHI JKL MNO
.@/: ABC DEF
SPACE DISPLAY
ENTER
ZOOM
REC MODE
VCR
RAPID PLAY
DVD
CM SKIP
SETUP
T-SET
OPEN/CLOSE
EJECT
TIMER PROG.
DUBBING
VCR/DVD RECORDER
COMBINATION
NB203ED
RETURN
OPERATE
2
3
4
5
7
1
8
• You can select a desired
channel number using [the
Number buttons]. Refer to the
following Channel Plan table
and press the three digits to
select the channel number.
(To select channel 4, press
[0] first and then press [0]
and [4]. Or press [4] and then
“– – 4” appears and wait for 2
seconds.)
• If this is the channel you want,
press [Cursor {].
Channel Plan in Australia
CH. Indication TV Channel
00 - 13 0 - 13
28 - 69 28 - 69
84 9A
85 5A
Channel Plan in New Zealand
CH. Indication TV Channel
00 - 02 1 - 3
06 - 09 4 - 7
10 - 12 9 - 11
21 - 74 21 - 69
84 8
This unit can receive the Hyper
and Oscar frequency bands.
• If “Skip” is set to “ON,” select
“Skip” using [Cursor K / L],
then press [Cursor B]. Select
“OFF” using [Cursor K / L],
then press [Cursor {].
• If you want to decode
scrambled signals, select
“Decoder” using [Cursor K / L],
then press [Cursor B]. Select
“ON” using [Cursor K / L], then
press [Cursor {].
• To store another channel,
repeat steps 4 to 7.
8
After completion, press
[SETUP] to exit.
Manually tune each channel.
1
In stop mode, press [SETUP].
2
Select “Channel” using [Cursor
K / L], then press [ENTER].
3
Select “Manual Tuning” using
[Cursor K / L], then press
[ENTER].
Manual Tuning
Position
Channel
Decoder
Skip
P01
2
OFF
ON
DVDVCR
4
Select “Position” using [Cursor
K / L], then press [Cursor B].
“P01” is highlighted.
5
Select the position number you
wish to use using [the Number
buttons] or [Cursor K / L], then
press [Cursor {].
You can select position numbers
01 to 99.
6
Select “Channel” using [Cursor
K / L], then press [Cursor B].
7
Press [Cursor K / L] to start
scanning.
• The tuner will begin to search
up or down automatically.
When a channel is found, the
unit will stop searching and the
picture will appear on the TV
screen.
Manual Tuning
6
7
5