Filter
Top Products
Initial auto installation
When the TV is powered on for the first time after purchase,
the initial auto installation wizard appears. Follow the menus
and make the necessary settings one after another.
1 Press a on the TV.
• The initial auto installation wizard appears.
2 Setting the OSD language.
Press a/b/c/d to select the desired language.
3 Setting the country.
Press ▲/▼/◄/► to select your country or area.
• This setting screen only appears during the initial auto
installation.
4 Select time zone.
5 Select broadcast settings.
Press ▲/▼ to select “Tuner type”. Press ◄/► to
select between differents tune type:
CADTV: Cable digital broadcasts.
ATV: Analogue broadcasts.
DTV: Digital broadcasts.
DTV + ATV: Digital and analogue broadcasts.
CADTV+ATV: Cable and analogue broadcasts.
SADTV: Satellite broadcasts.
SADTV + ATV: Satellite and analogue broadcasts.
6 Selecting the TV location.
Press ◄/► to select where you will use this TV, and
then press OK.
•HOME: For domestic use.
•STORE: DYNAMIC mode is predetermined. If the
Quick guide
Picture Mode is changed, the TV will automatically
switch back to DYNAMIC when there is no signal input
from the TV or remote control unit for 30 minutes.
If you have chosen STORE by mistake, go to Settings
→ Restore Factory Default → OK, and the TV returns
to the initial screen.
7 Starting channel search.
Press ▼ to select Next and then press OK.
• If you want to search for more broadcasts, execute
“DTV (or ATV, or CADTV) manual tuning” from the
menu “CHANNEL” (Page 22).
• To watch both analogue broadcasts and digital
broadcasts, you should perform the channel search
setting “DTV+ATV” or “CADTV+ATV”.
• Is not possible to search digital and cable digital
broadcasts at the same time.
8 The TV searches for, sorts and stores all the
receivable TV stations according to their settings
and the connected antenna.
• To cancel the initial auto installation in progress, press
END.
NOTE
• If you turn the power on the TV after performing step 4,
initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the Channel menu (Page 22).
• When "France" is selected in the Country setting, the PIN
code setting cannot be skipped.
• After initial Auto Tuning is completed, the default PIN is
automatically set to “3001”. To change the PIN setting, refer
to Lock menu on page 21.
If you install a DVB-T/T2/S/S2 antenna for the first time
of relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking the
antenna setup screen.
1 Press a channel you want to check.
2 Press MENU.
3 Press ► to select “Channel” menu and then press
OK.
4 Press ▲/▼ to select "Signal Information" and
then press OK.
5 Position and align the antenna so that the maximum
possible values for “Signal Strength” and “Signal
Quality” are obtained.
NOTE
• The values of “Signal Strength” and “Signal Quality” indicate
when to check the appropriate alignment of the antenna.
Checking quality and
signal strength
Home
Store
9
Confirm the following before turning
on the power
E Is the antenna cable connected?
E Is the AC cord plugged in?