Filter
Top Products
44
E
Controlling the Monitor with a PC
(Continued)
RS-232C command table
<How to read the command table>
Command: Command eld (See page 37.)
Direction: W When the “Parameter” is set in the parameter eld (see page 37), the
command functions as described under “Control/Response Contents”.
R The returned value indicated under “Reply” can be obtained by setting
“????”, “ ?” or “???+” (repeater control) in the parameter eld (see
page 37).
Parameter: Parameter eld (See page 37.)
Reply: Response (Returned value)
* “Yes” indicates commands which can be used in power standby mode.
TIPS
• To specify the horizontal/vertical positions for vertical orientation, specify the values for horizontal orientation.
Power control/Input mode selection
Control item
Command Direction
Parameter
Reply Control/Response contents
Can be used
in standby
mode
POWER CONTROL POWR W
0
Switches to standby mode.
Yes
1 Returns from standby mode.
R
0 Standby mode
1 Normal mode
2 Input signal waiting mode
INPUT MODE SELECTION INPS W
0 Toggle change for input mode
Yes
1 PC digital RGB (DVI) (DIGITAL)
2 PC analog RGB (ANALOG)
3 Component (COMPONENT)
4 Video (S-Video • Video)
R
1 PC digital RGB (DVI) (DIGITAL)
2 PC analog RGB (ANALOG)
3 Component (COMPONENT)
4 Video (S-Video • Video)