Filter
Top Products
16
IM-DR580H
03/10/15 IM-DR580H(E)2.fmIM-DR580H(E) TINSE0568AWZZ
Preparation
-Using with the Rechargeable Battery/Using with the Alkaline Battery-
Using with the Rechargeable
Battery (continued)
" Checking the remaining amount of battery
level
The remaining amount of battery level is shown by the
battery indicator ( ) during operation.
<On the remote control>
! When the battery is completely discharged, the battery
indicator will flash. Recharge the battery or replace the
alkaline battery with a new one.
! When the battery has run out completely, "LoBATT"
will appear. Then, the power will be disconnected
automatically.
Notes:
! If you use the battery which you stopped charging
halfway, " " may appear. It does not mean that the
battery is completely charged.
! The battery indicator will not correctly display the
remaining capacity for approximately 20 seconds after
the power has been turned on.
! When the AC adaptor is used, the battery indicator will
not be shown.
! The number of bars shown in the battery indicator may
increase or decrease, depending on the operation
being performed. This is normal.
Using with the Alkaline
Battery
Use one commercially available alkaline battery (LR6,
"AA" size).
The rechargeable battery can be used at the same time.
1
Open the case cover.
2
Insert an alkaline battery into the battery case.
Set the battery properly according to and inside
the case.
3
Attach the battery case to the portable MD.
Press
Open
Back of the
portable MD
RELEASE LOCK
1
2