Filter
Top Products
25
IM-DR580H
03/10/15 IM-DR580H(E)3.fmIM-DR580H(E) TINSE0568AWZZ
Recording
-Recording from a Stereo System, etc.-
To stop recording
Press the button.
Synchro recording is deactivated.
To use the last setting for synchro recording
Press the REC button to pause recording and press the REC
button for 2 seconds or more.
Synchro recording starts.
Recording pause and track numbering
! When the stereo system is stopped, the unit will enter the
synchro recording pause mode. When playback is
resumed, the recording will be resumed.
! If a silence lasts for 3 seconds or more, recording will be
paused (pause function does not work for approximately
10 seconds after the recording starts). When the unit
receives sound again, recording automatically starts.
! A new track number is created when the recording
resumes.
When track number setting is active
Tracks are numbered after a silence of more than 3 seconds
and at set intervals (see page 34).
(Example: the interval is 5 minutes)
Note:
Recording may not pause or resume at an appropriate timing
depending on the playback signal. In this case, perform
recording manually (see pages 22 - 23).
7
Press the MENU button.
The unit enters the menu select
mode.
8
Select "SYNC REC" by press-
ing the or button and
press the ENTER/-USB button.
9
Select "ON" by pressing the
or button and press the
ENTER/-USB button.
! "SYNC" will flash.
ON: Synchro recording is active.
OFF: Synchro recording is deac-
tivated.
10
Begin playback on the exter-
nal equipment.
Recording will begin automati-
cally.
Flashing
Lit Rotating
Silence of 3 seconds
or more
Silence of 3 seconds
or more
First
track
Second
track
Third
track
Silence of 3 seconds or more
(Track numbering in synchro recording)
Numbered after 5 minutes Numbered after 5 minutes
First
track
Second
track
Third
track
5 min 5 min
3