Filter
Top Products
52
5. Preset rate entry programming (Press
s
to skip. / Press
A
to terminate.)
6. Position of decimal point programming (Press
s
to skip. / Press
A
to terminate.)
7. Terminate programming
Item: Selection: Print:
A Open rate entry Enable* 0
Disable 1
B Preset rate entry Enable* 0
Disable 1
C TAB (position of decimal point from right) 0-3 (default:2)
Programming for
r
,
R
,
X
,
Y
,
c
and
b
The
X
key is used as an example below.
Programming for
r
and
R
, the step 3 and 4 are skipped.
1. Specify the key to program.
CH1 PROGRAMMING
ENTER[00]KEY
X
(1) Press the
X
key to enter
X
programming.
Immediately after displaying "CH1 PROGRAMMING",
guidance message for the next step will be displayed.
Operator displayKey operation
From left, ABC
Rate
Text
Print
0.00
A
(1) Press the
A
key to terminate the
V
key
programming.
ENTER[TL/NS]KEY
s
(2) Press the
s
key to register the setting.
2
2
(1) Enter the position of decimal point from right using
numeric key.
The position of decimal point from right can be set
from 0 to 3.
Default setting is 2.
TAB
2
s
(2) Press the
s
key to register the setting.
Immediately after displaying guidance message for
the next step, the current setting for the next step
will be displayed.
(1) Go to (2) when the preset rate entry does not need
to be changed from "PRESET ENABLE".
Otherwise, press
:
key to display "PRESEST
DISABLE".
Each time
:
key is pressed, the display shows "PRESET
DISABLE" and "PRESET ENABLE" alternatively.
Default setting is "ENABLE".
A203_3 FOR THE MANAGER(SEEG) 06.5.6 8:08 PM Page 52