Filter
Top Products
_ _ _ J_lo_/€_
• I R-904_(A) E_O 09Z007:R-904_(A) 2009-Z0-Z4 o$ Z:53 ..... :I,>....
_ SETTING THE SYSTEM j
0 SYSTEM
TONE :_/ON TRE :_/-10 ~ +10
PWR-M: /60/36/16/ON L__BASS:/-16- +16
. AMP (AMP ASSIGN) •To assign the surround back channels' power amplifier correctly depending on how to use the speakers.
. TONE •To adjust the tone (bass and treble) as desired.
. PWR-M (POWER MANAGER) •To set the POWER MANAGER mode depending on how to use the VuNow for power saving.
1, Press the CURSOR UP/DOWN buttons to select the desired item.
2, Press the CURSOR LEFT/RIGHT buttons to set the selected item as desired.
mWhen selecting the AMP ASSIGN
.The surround back channels' power amplifier can drive the surround back speakers or the ROOM 2 speakers. Depending on
how to use the speakers, you should assign the power amplifier correctly. (For details, refer to "CONNECTING SPEAKERS" on
page 8 and "CONNECTING ROOM2 SPEAKERS" on page 9.)
BACK (SURROUND BACK) •To drive the surround back speakers when connecting the SURROUND BACK!ROOM2 channels
to them.
R2 (ROOM2) •To drive the ROOM2 speakers when connecting the SURROUND BACK!ROOM2 channels to them.
mWhen selecting the TONE
OFF • To listen to a program source without the tone effect. ("DIR" lights up.)
$
ON • To adjust the tone for your taste. ("DIR" goes off.)
OWhen the TONE CONTROL is set to ON to adjust the tone (bass and treble)
_1). Press the ENTER button to enter the tone adjustment mode.
* Then "TRE ~" will be displayed.
_2_.Press the CURSOR UP/DOWN buttons to select the desired tone mode.
G). Press the CURSOR LEFT/RIGHT buttons to adjust the selected tone as desired.
* The tone level can be adjusted within the range of -10 ~ +10 dB.
* In general, we recommend the bass and treble to be adjusted to 0 dB (flat level).
* Extreme settings at high volume may damage your speakers.
* To complete tone adjustment, repeat the above steps _) and _).
mWhen selecting the POWER MANAGER
%FF : To turn on the VuNow circuitry constantly when this unit is turned on.
60 / 30 / 10 : If the specified period of time elapses after selecting the input source other than VuNow, the VuNow circuitry will
$ be turned off.
ON : To turn on the VuNow circuitry when the VuNow is selected as an input source.