Filter
Top Products
Operating a Cable Box or Satellite Receiver (SAT)
Setting the Manufacturer's
Code
You can program the supplied remote control
to operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE General Electric
(FUNCTION), and the 0-9 buttons to enter Hitachi
the manufacturer's code number (see the Hughes
following chart), then press ENTER. Panasonic
For example, to operate aSony satellite receiver: RCA!PROSCAN
Toshiba
Fj_ICl'O_
+ + +
Manufacturer code numbers
(cable box)
Manufacturer
Hamlin/Regal
Jerrold/GA
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Code
222,223,224,225,226
201,202,203,204,205,
222, 206,207,208, 218
227,228,229
219,220,221
214,215
209, 210,211
216,217
212,213
Manufacturer code numbers
(satellite receiver)
Manufacturer Code number
Sony 801 (preset code for
remote control)
802,808
8O5
804
803
802
806,807
To operate the cable box or
satellite receiver (SAT)
1 Press SAT/CABLE (POWER) [Green
Button! to turn on/off the cable box or
satellite receiver.
2 Press SAT/CABLE (FUNCTION).
3 For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blueqabeled)
buttons can be used only with a satellite
receiver.
If the remote control doesn't work
• Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
Tips "_"
• lfmorethanonecodenumberislisted, twentering
themonebyoneuntilyou cometothecorrectcode
for your equipment.
• If you enter anew code number, the code number
you previously entered at that setting is erased.
• Insome rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this easo, use the equipment's own remote control
unit.
Wheneveryou removethe batteries--toreplace
them, for example -- ff too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
49