Filter
Top Products
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
CD _
_ ©©
SONY
I JlkVA
Beta, Ed Beta VCRs AV1 303
8 mm VCR AV2 302
VHS VCR AV3 301
DVD player DVD 751
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedure to
program the remote control.
q2S
,_ The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
-q]
1
2
3
4
5
Turn to the list of "Manufacturer's Codes" on page 52, and find
the three-digit code number for the manufacturer of your
equipment. (If more than one code number is listed, use the
number listed first.)
Open the remote control and set the A/V slide switch to 1, 2, 3, or
DVD.
Press CODESET.
Enter the three-digit manufacturer's code number.
Press ENTER.
You must do step 5 within 10 seconds of step 4, or you must redo
steps 3 through 5.
6
To check if the code number works, aim the TV's remote control
at the equipment and press the POWERbutton that corresponds
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
Notes
If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
If you enter a new code number, the code number you previously
entered at that setting is erased.
In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment's own remote control unit.
J Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
51