Filter
Top Products
(US) 17
Installing and Connecting the TV
US
Setting the Channels
After you finish connecting your TV, you can run
Auto Program to set up your channels. The Auto
Program screen appears when you turn your TV on
for the first time after installing it.
To change or skip channels, see page 19.
Note
The Auto Program feature does not apply for an installation that
uses a cable box for all channels.
2
1 Press Power on the front panel of your TV. The
Auto Setup menu appears.
2 Press CH+ on the remote control or on the front
panel of your TV to perform Auto Program.
To perform Auto Program again
1 Press MENU.
2 Press V/v to select (TV Setup), then press
.
3 Press V/v to select “Auto Program,” then press
.
4 Press V/v to select “OK,” then press .
“Auto-Channel Set” appears and the TV starts
scanning and presetting channels automatically.
When all the receivable channels are stored, the
highest numbered channel will be displayed, then
the
(TV Setup) menu appears.
5 Press MENU to exit the menu screen.
To cancel Auto Program
While “Auto-Channel Set” appears in step 4, press
MENU on the remote.
1
MUTING POWER
VCR/DVD
SAT/CABLE
VCR/DVD
SLEEP
JUMP
VOL CH
ENTER
MTS/SAP
GUIDE
TV/SAT
SAT/CABLE
WIDE MODE DISPLAY
FUNCTION
TV
SYSTEM
OFF
VIDEO
FAVORITES
MENU
CODE SET
123
456
78
0
9
COMPONENT RGB
PICTURE
MODE
POWER
SAVING
TV
POWER
(Continued)
,
Auto Setup
Auto Program:
First please connect
cable antenna/
CH+
[
[
Exit
CH–
[
[