Filter
Top Products
25
Hookups and Settings
3 Press ENTER when “Finish” appears.
“Easy Setup” is finished.
To return to the previous step
Press O RETURN.
z Hints
• If your AV amplifier (receiver) has an MPEG
audio decoder, set “MPEG” to “MPEG”
(page 100).
• If you want to run “Easy Setup” again, select
“Easy Setup” from “SETUP” in the System Menu
(page 106).
Follow the steps below to set up your set top
box receiver for the GUIDE Plus+ system.
Note that the OSD language, Clock, Country
and Postal Code are all set for the GUIDE
Plus+ system when Easy Setup is completed.
1 Press TV GUIDE.
The GUIDE Plus+ system “Home
Screen” appears.
2 Select “Setup” in the Menu Bar using
M/,, and press ENTER.
The GUIDE Plus+ setup menu appears.
3 Select “Basic Setup” using M/m, and
press ENTER.
4 Select “External Receiver 1,” and
press ENTER.
You can also select “External Receiver
2” or “External Receiver 3” if you have
connected additional set top box
receivers.
5 Press ENTER to select “Continue.”
6 Select the set top box receiver type
using M/m, and press ENTER.
7 Select the provider using M/m, and
press ENTER.
If you select “None,” you can select a
receiver brand from a list of all available
brands.
8 Select the receiver brand using M/m,
and press ENTER.
If your receiver brand is not on the list,
select “???.”
The receiver brand list is automatically
updated, so your receiver may be
available at a later date. Select your brand
when it becomes available. Until then,
use “???.”
9 Select the connection you used for
your set top box receiver using M/m,
and press ENTER.
When the set top box receiver is
connected to the recorder using hookup
A or C, select “Antenna.” When the set
top box receiver is connected to the
recorder using hookup B, select “Line3.”
The display asks for confirmation.
10
Press ENTER to select “Continue.”
The Video Window switches to the
specified programme position.
11
Select “YES” using M/m, and press
ENTER.
The display asks for confirmation.
If the Video Window does not switch to
the specified programme position, select
“NO” and press ENTER until the Video
Window switches to the specified
programme position.
To receive Guide Plus+ system data
your recorder must be turned off
when not in use. If your recorder is
connected to a set top box receiver, be
sure to leave the set top box receiver
turned on. After initial setup, it may
take up to 24 hours to begin receiving
TV programme listings.
Setting up your set top box
receiver for the GUIDE Plus+
®
system
,continued