Filter
Top Products
82
Appendix: Other Information
Using the Learn Function
You can program the DSS remote commander to learn the functions of
another component’s remote control. Use this function to operate
components that are not listed in “Programmable Codes” on page 80.
To use the Learn function:
1
Set the slide switch in the inside panel to VTR3 or MDP.
2
Place the DSS remote commander and the other component’s
remote control directly facing each other, about two inches apart.
3
Press the LEARN button. The Learn indicator lights.
4
Press the button on the DSS remote commander that you want to
learn a function. The Learn indicator flashes off, then on, indicating
that the DSS remote commander is now ready to learn.
5
Hold down the corresponding button on the other component’s
remote control. When the Learn indicator flashes off, then on,
release the button on the other component’s remote control.
If the indicator doesn’t flash, repeat steps 4 and 5.
6
To learn other functions, repeat steps 4 and 5.
About the Learn Function
The Learn function does not work in the VTR1 and VTR2 slide
switch positions.
During the learning procedure, do not move the remote controls.
If you press a button on this remote commander that cannot be
used for learning, the Learn indicator flashes four times.
To clear all learned signals from memory, set the slide switch inside
the lid to MDP, press the LEARN button, press the DSS POWER
button while holding down the VOL- button, and then press the
LEARN button again.
When you remove the batteries — to replace them, for example —
any codes you’ve set may be erased.
Approx. 2 inches