Filter
Top Products
11
Getting Started
If you have a digital component such as a
receiver (amplifier) with a digital connector, DAT
or MD
Connect the component via the DIGITAL OUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied).
When you play a DVD, set “DIGITAL OUT” in “AUDIO SETUP”
to “ON” and then set “DOLBY DIGITAL” to “D-PCM” and
“DTS” to “OFF” in the setup display (page 64).
pWhen using an optical digital connecting cord
Take off the cap and plug in the optical digital connecting cord.
pWhen using a coaxial digital connecting cord
Notes
• Refer to the instructions supplied with the component to be
connected.
• You cannot make digital audio recordings of discs recorded in
multi-channel surround format directly using an MD deck or
DAT deck.
When you make the connections above, do not set
“DOLBY DIGIT AL” to “DOLBY DIGITAL” and “DTS” to
“ON.” If you do, a loud noise will suddenly come out
from the speakers, affecting your ears or causing the
speakers to be damaged.
Optical digital connecting cord
(not supplied)
CD/DVD player
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
Coaxial digital connecting cord
CD/DVD player
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
If you have an audio component with a built-in
DTS decoder or Dolby Digital decoder
Connect the component via the DIGITAL OUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied).
p When you play a DVD that is recorded in DTS format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then
set “DTS” to “ON” in the setup display (page 64).
p When you play a DVD that is recorded in Dolby Digital
format
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then
set “DOLBY DIGITAL” to “DOLBY DIGIT AL” in the setup
display (page 64).
Notes
• Refer to the instructions supplied with the component to be
connected.
• When you do not connect an audio component with a built
in DTS decoder, do not set “DTS” to “ON.”
• When you do not connect an audio component with a built
in DOLBY DIGIT AL decoder, do not set “DOLBY DIGIT AL” to
“DOLBY DIGITAL.”
Setups for the player
Some setups are necessary for the player depending on
the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 55.
• To listen to the sound through speakers connected
to a receiver (amplifier) having a digital connector or
to output the sound to a digital component such as
a DAT or MD deck
When you play a DVD, set “DIGITAL OUT” in
“AUDIO SETUP” to “ON” and then set “DOLBY
DIGITAL” to “D-PCM” and “DTS” to “OFF” in the
setup display (page 64). These are the default settings.
CD/DVD player
Audio component
with a built in
DTS decoder or
DOLBY DIGITAL
decoder
Optical or coaxial digital
connecting cord
Speakers
(not supplied)
DIGITAL IN
OPTICAL
OPTICAL COAXIAL
PCM/DTS/
DOLBY DIGITAL
(
AC-3
)
DIGITAL OUTPUT
DIGITAL IN
COAXIAL
OPTICAL COAXIAL
PCM/DTS/
DOLBY DIGITAL
(
AC-3
)
DIGITAL OUTPUT