Filter
Top Products
8 (GB)
Location and Function of Parts and Controls
1 (standby) Switch / Indicator
Section
1 1 (standby) switch
Press to turn on the display unit. Press again to go
back to the standby mode.
Note
To protect the panel, a certain amount of time is
required to turn the unit ON/STANDBY. Wait about 8
seconds after one of these operations before pressing
this switch again.
2 STANDBY indicator
Lights up in red in the standby mode.
When the STANDBY indicator flashes, see “Self-diagnosis
Function” on page 47 (GB).
3 ON indicator
Lights up in green when the display unit is turned on.
4 Remote control detector
Receives the signal from the Remote Commander.
Control Button Section (Top)
1 MENU button
Press to make the menu appear. The menu is no
longer displayed when this button is pressed again.
When using the MENU button to return to the previous
menu level, see “Initial Setup menu” on page 23 (GB).
2 m/M buttons
Press to move the cursor (yellow) to an item or to
adjust a value in a menu.
3 ENTER button
Press to select the desired item from the menu
displayed.
4 VOLUME +/– button
Press to adjust the volume of the sound emitted from
the speakers.
O
N
STAN
D
BY
2
1
3
4
MENU ENTER VOLUME
123 4