Sony SAT-A65A Satellite TV System User Manual


 
Getting started 5
Testing your system
When you have aligned your dish antenna to the azimuth and elevation angles
shown on the
Antenna pane:
1. Highlight the
Signal tab.
2. Use the button to highlight the Source pull-down menu
3. Signal quality is indicated by a scale at the bottom of the pane and with an
audible indication. The frequency and tempo of the tone increase with
signal strength.
4. Highlight the Transponder pull-down menu.
5. You may need to select another transponder to achieve the highest signal
indication.
6. Select the transponder providing the best signal.
7. Use the button to highlight the
Test tab.
8. Highlight Begin Test and press the
SELECT button.
Results appear within a few seconds and should resemble those in the figure.
If your test results are much different from those shown in the figures, or you
receive no signal indication, refer to page 6.
To perform the Transponder test:
1. Move the highlight to the Xponder Test pull-down menu.
2. Press the
SELECT button.
SIGNAL STRENGTH
Prefs
Antenna
Signal
Return
Wed, Aug 1 5:14 PM
Test
New Card
Upgrade
Features
Exit
VCR
Status: Unlocked
04
Source
Transponder
Signal Strength
Current: 95 Highest: 95
Satellite 101
(A)
o
SYSTEM TEST
Prefs
Antenna
Return
Wed, Aug 1 5:12PM
Test
New Card
Upgrade
Features
VCR
Xponder Test
System Test
Begin Test
Exit
Version
Wink Version
Tuning
: 5317.6
: 0.0.0.75
:OK
:OK
:OK
:OK
Front Panel
:OK
(ID 0000-0000-0000)
Signal
Signal
Phone
Access Card