Filter
Top Products
20
Using TV Features
Overview of the Remote Control and TV Controls/Indicators
When using the remote control for the first time
Pull the insulation film out from the remote control.
When changing the battery
Unlock the battery holder by pushing a pen tip into
the hole located on the rear of the remote control.
Slide the battery holder out. Replace the battery with
CR2032 (lithium) battery with e side up in the
battery holder of the remote control.
Inserting Batteries into the Remote Control
Remote Control
Button Description
1 DISPLAY Press once to display the information pertaining to the
channel and/or program when available. The OSD (On Screen
Display) will time out in a few seconds or press again to
immediately turn off the display. You can also set the display
to show minimal information. See Info Banner on page 41.
2 CC Press to turn on and off the Closed Captions (CC). To change
or customize the CC Display, see page 38.
3 DMe
x
Press to access features in the optional BRAVIA external
module (e.g. DMX-NV1). See your dealer or
www.sony.com/bravia for more information. The module may
not be available in your region.
4 SOUND Press to cycle through different sound settings: Dynamic for
enhancing treble and bass, Standard for spoken dialog and
Custom for flat setting (see page 34).
5 0-9 ENT Press 0-9 to select a channel; the channel changes after two
seconds. Press ENT to change channels immediately.
6 Use with 0-9 and ENT to select digital channels.
For example, to enter 2.1, press , , and ENT.
Slide to open
~
• This remote control cannot be programmed to use with other equipment.
•The 5 button and CH + have a tactile dot. Use them as a reference when
operating the remote control.
• This remote control is designed to operate at fairly close range from the TV.
If you use with other Sony TVs, operate it near the TV you want to control.
1
2
3
4
6
5
2
1