Filter
Top Products
FIVE Monitor Functional Description 4.14
MMaasstteerr MMoodduullee
1
LLAAMMPP DDIIMMMMEERR
The Lamp Dimmer controls the voltage to the 4-pin XLR socket which is provid-
ed for the connection of Littlites.
The pinout is as follows:
Pin 1 & 3 +/-12V
Pin 4 0v
max. current 400mA
2
PPSSUU RRAAIILLSS
Three LEDs monitor the status of the power supply rails.
3
MMUUTTEE FFLLAASSHH DDIISSAABBLLEE
When an input channel MUTE is triggered by the MUTE switch of either a VCA
Master or a MUTE master, it will flash to show that it is under the control of a
remote trigger. This flashing may be disabled with the MUTE FLASH DISABLE
switch (which is recessed to avoid accidental selection).
OOSSCCIILLLLAATTOORR SSEECCTTIIOONN
The oscillator generates either tone or pink noise, and has its own independent
balanced XLR output on the rear panel. The oscillator can be routed to all busses
simultaneously.
4
PPIINNKK
The oscillator generates either TONE (switch released), or pink noise (switch
pressed and illuminated).
5
FFRREEQQ // XX1100
The frequency range of the oscillator is variable form 63Hz to 1kHz. Pressing the
x10 switch (internal LED lit)provides a higher range of 630Hz to 10kHz.
66
LLEEVVEELL
This control adjusts the oscillator level to both the XLR output and the internal
busses.
7
OOSSCC TTOO XXLLRR OOUUTTPPUUTT // AALLLL BBUUSSSSEESS
The rear panel OSC OUT XLR is enabled when the OSC TO (XLR OUTPUT)
ON switch is pressed. The internal illumination indicates when the output is
active.
The Oscillator may also be routed directly to all busses simultaneously by pressing
the OSC TO (ALL BUSSES) ON switch (LED illuminated) where it mixes with
any existing signal.
TTAALLKKBBAACCKK SSEECCTTIIOONN
The TALKBACK system allows communication by the operator to the Group and
Matrix Outputs, and to and from the front of house (FOH) console.
8
TTAALLKKBBAACCKK MMIICC
Talkback Mic input XLRs are provided on the front and rear panel.
9
LLEEVVEELL
This control adjusts the gain of the Talkback Mic preamp over a 30dB range.