SRS Labs Plasma Display Panel Television Flat Panel Television User Manual


 
English - 15
Fine Tuning Channel Reception
If the reception is clear, you do not have to fine tune the channel, as this is done
automatically during the search and store operation.
If the signal is weak or distorted, you may have to fine tune the channel manually.
1 Press the MENU () button to display the menu.
2
Press the or button to select Channel, then press the
ENTER/OK ()
button.
3
Press the or button to select Fine Tune, then press the ENTER/OK () button.
4 To obtain a sharp and clear picture and good sound quality, press the œ or button until you reach the optimal
setting.
Press the
ENTER/OK ()
button.
To reset the fine tuning to 0, select Reset by pressing the
or
button.
Press the ENTER/OK () button.
5 Press the EXIT button to exit.
Fine Tune Store will change the colour of the Channel OSD (On Screen Display) from White to Red and
add the “*” mark.
P1
*
Mono
P1
*
+
3
Reset
Fine Tune
Adjust Save Return
Not available in DTV or external input mode.
1 Press the MENU () button to display the menu.
2
Press the or button to select Channel, then press the ENTER/OK ()
button.
3 Press the
or
button to select LNA, then press the ENTER/OK ()button.
4 Select Off or On by pressing the or button, then press the ENTER/OK () button.
5 Press the EXIT button to exit.
Depending on areas, factory mode of LNA, will be set up as On or Off.
LNA (Low Noise Amplifier)
This function is very useful in the situation that the TV is used in weak signal.
LNA amplifies the TV signal in the weak signal area, a low-noise preamplifier
boosts the incoming signal.
Channel
Move Enter Return
Country : Belgium
Auto Store
Manual Store
Channel Manager
Sort
Name
Fine Tune
LNA : Off
TV
You can select the type of picture which best corresponds to your viewing
requirements.
1 Press the MENU () button to display the menu.
2
Press the or button to select Picture, then
press the
ENTER/OK ()
button.
3 Press the ENTER/OK () button twice.
4 Select the required mode by pressing the or button, then press the ENTER/OK () button.
A
vailable modes: Dynamic, Standard, Movie, Custom
The settings values may vary depending on the input source. (ex. RF, Video, Component, PC, or HDMI)
5 Press the EXIT button to exit.
Choose Dynamic for viewing the TV during the day or when there is bright light in the room.
Choose Standard for the standard factory settings.
Choose Movie when viewing the movie.
Choose Custom if you want to adjust the settings according to personal preference.
Changing the Picture Standard
Mode
Move Enter Return
Mode : Dynamic
Contrast 100
Brightness 50
Sharpness 75
Colour 55
Tint G 50 R 50
Colour Tone : Cool1
Reset
TV
Dynamic
Standard
Movie
Custom
)
l.
)
en
by
on
BN68-00889W-01Eng(Spa) 9/20/06 3:15 PM Page 15