Filter
Top Products
English - 27
Operating the DTV Menu
1.1 Select Country
To tune-in new channels, the TV has been provided with the option
“Select Country”. Select the country where broadcasting services are
provided. After selecting the “Select Country” from the Installation
Menu, the following screen will be displayed:
• Select the country which you are in.
You can select the value of ITALY, SPAIN, SWEDEN, UK, USER, BELGIUM,
GERMANY, FINLAND, or FRANCE by using œ or √ button.
• After selecting option, press the ENTER/OK () button to choose the
nation of broadcasting area to be served. If you don’t want to save the
changes, press EXIT button without ENTER/OK () button pressed.
➢
If national code is changed, all of saved programs will be deleted.
➢
USER: An user may set Channel Number and Frequency in Auto/Manual
scanning.
1.2 Auto Scanning
The sub menu “Auto Scanning” will enable download of the channels
automatically from the preprogrammed load.
To download channels automatically:
•You can select the specified frequency between Start Frequency and
End Frequency.
• Press the ENTER/OK () button.
Auto Scanning menu will be displayed.
All the channels in the list will be automatically downloaded.
1.3 Manual Scanning
To tune-in new channels and weak signals, the TV has been provided
with the option “Manual Scanning” where the channel data can be
entered by the user. After selecting the “Manual Scanning” from the
Installation Menu, the following screen will be displayed:
• Select the Channel Number.
You can select the specified channel you want to find.
The followings are defined as a default, but optionally you can choose it.
Signal Status bar shows you if it is valid.
• Input the frequency of the channel you want to find.
• Select the bandwidth. You can select the value of 6 MHz, 7 MHz or 8 MHz.
• Select the Guard Interval Mode.
You can select the value of AUTO, 1/32, 1/16, 1/8, or 1/4.
• Select the FFT (Fast Fourier Transform) Mode.
One of the values-AUTO, 2 K, and 8 K- will be selected automatically.
You may change the set value as your preference.
• After selecting option, press the ENTER/OK () button to start the
scanning process.
1.4 Reset to Factory Defaults
This is to restore the factory set values in case the user has encountered
some problems after changing any values of channel data and others which
may be in error. At the request window, if you press the ENTER/OK ()
button, the TV will be reset to factory default settings automatically.
➢
This causes your previous settings to be deleted!