SRS Labs Plasma Display Panel Television Flat Panel Television User Manual


 
English - 9
Installing Batteries in the Remote Control
1 Lift the cover at the back of the remote control upward as shown in the figure.
2 Install two AAA size batteries.
Make sure to match the “+” and “–” ends of the batteries with the diagram
inside the compartment.
3 Close the cover as shown in the figure.
Remove the batteries and store them in a cool, dry place if you won’t be using
the remote control for a long time. The remote control can be used up to
about 23 feet from the TV. (Assuming typical TV usage, the batteries last for
about one year.)
If the remote control doesn’t work! Check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?
The main lead is attached to the rear of the television.
1 Plug the main lead into an appropriate socket.
The main voltage is indicated on the rear of the television and the frequency is 50 or 60Hz.
2 Press the (Power) button (On/Off) on the front of the television or press the POWER ()button on the remote
control to switch the television on. The programme that you were watching last is re-selected automatically. If you
have not yet stored any channels, no clear picture appears. Refer to “Storing Channels Automatically” on page
11 or “Storing Channels Manually” on page 12.
If the television is initially powered on, several basic customer settings proceed automatically.
Refer to “Plug & Play Feature” on page 10.
3 To switch the television off, press the (Power) button (On/Off) on the front of the television or press the
POWER ()button on the remote control.
4 To switch the TV on, press the (Power) button (On/Off) on the front of the TV or press the POWER ()button
or number buttons on the remote control.
Switching Your Television On and Off