Filter
Top Products
Device Menu
15
an IR signal to the desired device. Both the device and
the IR-extender must be set to the same RF address to
operate properly. To set the RF address:
1. Press
or to select RF ADDR
2. Press Ok
3. Select either IR to operate in
the IR mode or an RF address
(0-9) for the IR-extender.
4. If an RF address is selected on
the SRC-3815, set the IR-
extender (SEL-6000) to the
same RF address by adjusting
the ADDRESS wheel on the rear
panel as needed (0~9).