Filter
Top Products
SRC-38 SERIES User’s Manual
50
The SRC-3810/3815
doesn’t operate a
device.
In RF mode:
Make sure the SEL-6000 IR-extender is
aimed at desired equipment.
Make sure RF Address on IR-extender
matches settings in SRC-3815.
You cannot operate
a device even after
teaching the device
using the learning
function.
Make sure that your SRC-3810/3815 has
correctly “learned” device's remote
control code. (page 21).
Delete the device data from the SRC-
3810/3815 and carry out the learning
function again (page 20).
Make sure you did not program more
than one remote for a given device.
You see “ERROR”
display on the LCD
during the learning
procedure.
Make sure you hold the other remote’s
button down for about 2 seconds.
Make sure you did not program more
than one remote for a given device.
Make sure the two remotes are not too
close or too far apart and are aiming
directly at each other - keep apart
between 2~4 inches (5~10cm).
You see “ERROR”
display during
operation.
The button that you pressed has not
been taught.
Learn the button using the learning
procedure (page 20).
Your VCR will not
record.
As a safety feature on SRC-3810/3815,
you must press the REC key for 2 seconds.
Problems changing
channels.
If your original remote requires the ENTER
key to be pressed after a channel is
selected, press the ENTER key to select
the channel.