Filter
Top Products
SurfControl Web Filter for ISA v5.5 Starter Guide 19
I
NSTALLATION
D
ECISIONS
User Name Resolution
2
How to configure the file
The table below describes the various sections of the EumLogin.ini file and how to enter your information.
Table 2-3 The EumLogin.ini file sections
Section What to enter
[Surfcontrol_Servers] Enter the name, or IP address, of each server in your organization that Web
Filter is installed upon. The format is:
Servers=Servername1,Servername2,127.0.0.1
Note: Do not leave spaces between the server names.
[SERVERNAME] For each server specified in [Surfcontrol_Servers], make an entry along
with the default Web Filter listening port (61695) for Windows, or the default port
(61696) for Netware.
For example, the format for a Windows 2000 or 2003 domain is:
[Servername1]
Port=61695
[Servername2]
Port=61695
[127.0.0.1]
Port=61695
The format for a Netware domain is:
[Servername1]
NetwarePort=61696
[Servername2]
NetwarePort=61696
[127.0.0.1]
NetwarePort=61696
[Continuous_Mode] The Login Agent runs in continuous mode. The agent will send log on and log
off details to the servers specified in [Surfcontrol_Servers] at a specified
interval (in seconds). The default setting is 900 seconds.
The format is:
Interval=900
[Retry_Connection] If a connection to any of the servers specified in [Surfcontrol_Servers] is
dropped, the Login Agent will try to re-connect. This entry specifies how many
times the agent will attempt to re-connect. If connection is not re-established
after the number of times specified, the agent will wait for the interval specified
in [Continuous_Mode] before attempting to connect again. The maximum
value is 5. If you enter a value higher than 5 the Login Agent will only try 5 times.
The format is:
Retry=5