Filter
Top Products
Camera Connection
Audio connection
TV Monitor Connection
VGA Monitor Connection
Network Connection
RS-232 Connection
Connect the CCD cameras to VIDEO IN on the rear panel of the DVR.
Connect the USB mouse or USB storage to USB port on the rear panel of the DVR.
Connect a microphone to AUDIO IN 1 & 2 and speaker to AUDIO OUT on the rear panel
of DVR. Audio input and output should be amplified, since the DVR does not have an
embedded amplifier.
Connect the VGA monitor to the VGA on the rear panel of the DVR.
Connect the sensor and alarm to the Alarm In & OUT on the rear panel of the DVR.
Connect the Normal LAN cable, connected to the network, to the network RJ-45
connector on the rear panel of the DVR.
Connect the cable to RS-232 connector on the rear panel of the DVR.
RS-485 Connection
Connect the cable to RS-485 connector on the rear panel of the DVR.
Power Connection & Power Switch
USB Connection
Connect the power cord to the MAIN POWER connector on the rear panel of the DVR.
The DVR is booted up when Power Switch turns on.
Reset (ID & PW reset)
Alarm In & Alarm Out
RESET button is only used to restore ID & PW to factory defaults. To initialize DVR’s ID &
PW, press the RESET button with a straight clip for about 3 seconds. When it is reset
completely, the ID & PW reset message will displayed on screen.
If you want to use a TV monitor, connect the TV cable to VIDEO OUT on the rear panel of
the DVR. But you may not see almost OSD on TV monitor.
CAMERA × 16
POWER CONNECTION
& POWER SWITCH
ALARM IN & OUT
AUDIO/MIC
VGA MONITOR
NETWORK
RS-485
RS-232
VIDEO OUT
USB MOUSE
RESET
8
5
V
VI
I
DE
DE
O
O
O
OU
U
CAMERA CONNECTION