Filter
Top Products
41
No picture,no sound,display is off
No picture,no sound,display is on
Screen display „Pulse count error“
Screen display „Motor overload“
Screen display „Auto-focus error“
Outdoor unit moves in wrong direction
The automatic satellite scan feature does not find any
satellites
The automatic satellite scan feature does not find a
number of satellites
Outdoor unit moves but does not find any satellite positions
check mains cable and connector
check all cable connections (see 4 „Connections“)
set channel 39 on the television set (see operating
instructions of the TV set)
select the right outdoor unit
check all cable connections (see 4 „Connections“)
move dish in reverse direction
Use an appropriate motor
not necessary
change motor connections M1 and M2
first of all,select the westernmost satellite (see 5.4)
select manually (see 5.4)
select manually (see 5.4)
consult a specialist to have the trajectory adjusted correctly
mount the polarizer according to the instructions
No supply voltage
cable connection is broken or missing
television set is set to the wrong channel
wrong outdoor unit selected
cable connection is broken or missing
you have reached the East or West limit
The power requirements of the connected motor are
too high
Due to a weak receive signal,auto-focus could not
detect optimal positioning; receiver uses the stored
position
motor connections M1 and M2 exchanged
automatic scan only works from West to East
Low receive quality
Other satellites are using the same broadcasting
frequencies
wrong outdoor unit selected
outdoor unit trajectory adjusted incorrectly
polarizer mounted incorrectly
9 Troubleshooting notes
Error Possible cause Measures
*M-Focus 2.6.95 14.12.1999 10:39 Uhr Seite 41