Filter
Top Products
42
Some satellites have good others have a bad receive quality
The channels of a particular satellite have different receive qualities
Some channels of a particular satellite cannot be received at all
Some satellites and channels are missing in the list of satellites or channels,
resp.
The receive quality of some satellites has become lower
All satellite channels display “wavy lines“
A channel that is received via antenna displays “wavy lines“
The picture is full of black and white points (“little fish“)
Sound ok.,no picture
Picture ok.,no sound
Channel picture or sound disturbed,though working ok.before
Some channels cannot be selected pressing PROGR
A connected decoder does not decode
mount the polarizer according to the instructions and correct the skew
parameters (see 7.7)
consult a specialist to have the trajectory adjusted correctly
use a larger reflector
use a larger reflector
Use a different LNB
store the satellite positions (see 5.4 and 5.5)
re-adjust the outdoor unit
change transmit channEl on the receiver (see 4.2)
change transmit channel on the receiver (see 4.2)
remove the snow from the outdoor unit
switch to TV mode (see 6.5)
connect adequate decoder (see 4.5)
check the volume on the television set
check the volume on the receiver (see 6.4)
set up channel again (see 7.7)
connect adequate decoder (see 4.4 „Decoder“)
no measures
select channel (see 7.3)
Check the decoder’s instructions
check the connections (see 4.5)
correct the setting (see 7.6)
incorrect skew setting
outdoor unit trajectory adjusted incorrectly
reflector is too small for the satellite
The channels are broadcast at different power levels
your LNB is not apt to receive at such frequencies
the satellite positions have not been stored
the outdoor unit has moved
receiver transmits on a channel which is used for reception via antenna
receiver transmits on a channel which is used for reception via antenna
heavy rain or snow
you have selected a radio channel
channel is encoded
television is set to mute mode
receiver set to mute mode or volume to low
audio or video settings have been modified
channel is encoded now
channel is no longer broadcasting
channels has been deleted
key or SmartCard is not valid
wrong SCART connection
wrong decoder signal selected
Error Possible cause Measures
*M-Focus 2.6.95 14.12.1999 10:39 Uhr Seite 42