Filter
Top Products
Communications Teledyne API T703/T703U Calibrator Operation Manual
100
5.1.2. SERIAL COM PORT DEFAULT SETTINGS AND CONNECTOR PIN
ASSIGNMENTS
Received from the factory, the calibrator is set up to emulate an RS-232 DCE device.
RS-232 (COM1): RS-232 (fixed), DB-9 male connector.
Baud rate: 115200 bits per second (baud).
Data Bits: 8 data bits with 1 stop bit.
Parity: None.
COM2: RS-232 (configurable to RS 485), DB-9 female connector.
Baud rate: 19200 bits per second (baud).
Data Bits: 8 data bits with 1 stop bit.
Parity: None.
Figure 5-1: Default Pin Assignments for Rear Panel COM Port connectors (RS-232 DCE & DTE)
The signals from these two connectors are routed from the motherboard via a wiring
harness to two 10-pin connectors on the CPU card, J11 and J12.
07223C DCN6572