Filter
Top Products
Teledyne API T703/T703U Calibrator Operation Manual Operating the Calibrator
83
4.9.2.2. Automatic TEST Channel Calibration
To calibrate the outputs as a group with the AOUTS CALIBRATION command, press:
NOTE
Before performing this procedure, make sure that the AUTO CAL feature is turned OFF for CONC_OUT_1
and CONC_OUT_2,
Make sure that the AUTO CAL feature is turned ON for the TEST CHANNEL (See Section 4.9.2.1)
NOTE:
Manual calibration should be used for the 0.1V range or in cases where the outputs must be closely
matched to the characteristics of the recording device.
07223C DCN6572