Filter
Top Products
Teledyne API T703/T703U Calibrator Operation Manual Operating the Calibrator
55
4.5.1.3. Setting the Repeat Count for a Sequence
The sequence can be set to repeat a certain number of times, from 1 to 100. It can also
be set to repeat indefinitely by inputting a zero (0) into the REPEAT COUNTER.
To set the REPEAT COUNTER, press:
SETUP X.X REPEAT COUNT:1
<SET SET> EDIT EXIT
SETUP X.X NAME:[0]
0 0 1 ENTER EXIT
EXIT discards the
new NAME
ENTR accepts the
new NAME
Toggle these buttons to set the repeat count from 1 to 100.
Enter “0” to cause the sequence to loop indefinitely
Continue pressing SET> until ...
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the
calibrator is in standby
mode.
SETUP X.X PRIMARY SETUP MENU
O3 SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
This display only appears if there are no sequences currently
programmed into the calibrator.
OTHERWISE ...
07223C DCN6572