Filter
Top Products
Operating the Calibrator Teledyne API T703/T703U Calibrator Operation Manual
94
4.12.5. PROGRAMMING NEW LEVELS
To begin programming a new LEVEL find the LVL submenu by pressing:
CHOOSE ACTION Submenu
SETUP X.X ACTION TO PERFORM:GENERATE
PREV NEXT ENTR EXIT
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the
calibrator is in standby
mode.
SETUP X.X PRIMARY SETUP MENU
O3 LEVL SEQ CFG CLK PASS MORE EXIT
SETUP X.X END OF LEVELS
INS PRNT EXIT
SETUP X.X [LEVEL ID] ) [Gas/Conc.], [Status Block Set]
PREV NEXT INS DEL EDIT PRNT EXIT
Deletes the LEVEL shown
in the message field
Edits the LEVEL shown in
the message field
Scrolls back and forth between
existing LEVELS
This display only appears if there are no LEVELs currently
programmed into the calibrator.
OTHERWISE ...
Toggle to scroll though the available instructions:
GENERATE & MANUAL
07223C DCN6572