Filter
Top Products
Operating Instruction Book
TU-HDT104A
12
4.5 Select Aspect Ratio
The first time the digital receiver is installed, or after Shipping Condition is restored
(section 6.4), you will be asked to select your preferred aspect setting. This may be a
choice of the Wide (16:9), Normal / Center Cut (4:3) or Normal / Letter Box (4:3).
4.6 Autotune
The first time the digital receiver is installed, or after Shipping Condition is restored
(section 6.4), the digital receiver will automatically scan for available digital services.
This will take around five minutes or so.
5 Operating Instructions: Knowing your basic controls
To become acquainted with the operations and functions of your receiver, you should
learn how to use the control buttons on the Front Panel and the Remote Control.
The following segment is an introduction to features that you will most commonly use.
5.1 Switching On Your Digital Receiver
Before you switch on your receiver please ensure the power lead is plugged into a
240V AC socket. Remember that as long as the digital receiver remains plugged into
a 240V supply, the receiver will be in constant “STANDBY”.
Switch on your receiver by pressing either the button on the remote control or the
button on the front panel. While the digital receiver is in normal viewing mode, the
green LED lights up. When not using the digital receiver, put your equipment in the
“STANDBY” mode by pressing either one of the / buttons again. When the red
“STANDBY” LED lights up, it indicates the digital receiver is in “STANDBY” mode.
The front panel will show current local time.