Technicolor - Thomson TU-HDT104A DVR User Manual


 
Operating Instruction Book
TU-HDT104A
9
4.2 Output Mode Selection
After you have connected the AV cables for video and audio between your digital
receiver and the display device, check that the position of the output selection switch
is correct for your chosen connection method as in the table below.
Switch Position Video Output Format Receiver Mode
A YPbPr (Component Video) SD / HD
B RGB HD
C CVBS / S-Video SD
Switch on the digital receiver and the display device, and select the correct AV input
on the display device. The digital receiver will take about 10 seconds to switch on.
You may now start the installation procedure.
The installation procedure is used to set up the video formats that may be output from
the digital receiver to the display device. During this procedure the digital receiver
may test if the display device is capable of correctly displaying 576i, 576p, 1152i,
1080i and 720p video formats. You will be asked to test these video formats on the
display device and confirm if the picture is displayed correctly. If the display device is
not capable of displaying a particular video format, the digital receiver will return to the
last correctly displayed format after about 8 seconds.
Note: In some cases, a display device will fail to return to a previously tested mode
after failing to display the next mode (i.e. the display does not support this format). If
you experience this, turn the display device off, wait 10 seconds and then turn the
display device on.
Installation Format Selection
Use the Remote Control keypad to perform the digital receiver format testing and
installation. Follow the digital receiver’s on-screen instructions to do the installation.
Mode A (SD/HD, YPbPr)
The switch on the rear of the digital
receiver must be in position A, and the
AV connections must be taken from
the YPbPr RCA sockets. The digital
receiver display will show “HdcI”.
Press OK to confirm the selection, or
switch to another mode. Proceed to
INSTALLATION.
Note: If the display device is not capable of displaying 576i, you can press the Mosaic
button to change to 576p.