Filter
Top Products
16
Reference
Using the
Remote Control
Programming the remote control for use with
your audio/video devices
Device code setup
1. Refer to the Device code table on pages 18–21 to find the code
for your device.
If more than one code is listed, try each one separately until you
find the one that works.
2. Press MODE until the mode indicator of the device (CABLE/
SAT, VCR, DVD, AUDIO1, AUDIO2) lights up.
3. While holding down RECALL, press the CHANNEL
NUMBERS to enter the four-digit code for your device.
Release the buttons.
If a valid code is entered, the mode indicator will blink twice.
If an invalid code is entered, there will be one long blink.
4. Point the remote control at the device and press POWER to test
the code.
If the device turns on, you have entered the right code.
If the device does not respond to the remote control, you may
have entered an invalid code. Repeat steps 3 and 4 using another
code.
5. To control the TV, press MODE until TV mode lights up.
Searching and sampling the code of a device (991)
If you do not know the device code for a particular device, you can
cycle the remote control through the available codes for that device
and sample functions to find the code that operates the device. The
keys available to be sampled, provided they are applicable to that
mode, are 0, 1, 2, 3, POWER, VOL y, CH y, PLAY, and STOP.
Invalid keys will be ignored while in program mode.
To cycle through each available device code and sample its functions:
1. Press MODE to select the mode you want to set up.
2. While holding down RECALL, press 9, 9, 1 in sequence. The
remote control will enter program mode.
3. Point the remote control at the device, and then press POWER
(or other function buttons that are available to be sampled).
4. If the device responds to the remote control:
Press RECALL to store the device code.
The mode indicator will blink two times, and the remote
control will exit the program mode.
If the device does not respond to the remote control:
Press y, and then press POWER.
Repeat this step until the device responds to the remote
control, and then press RECALL.
Note: When a search cycle is done, the mode indicator will blink three times.
The remote control will begin to cycle through the available codes again.
If no key is pressed within 10 seconds while programming, the remote
control will exit the program mode and return to the previous code.
POWER
CHANNEL
NUMBERS
RECALL
Note:
• Every time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
MODE
y