Filter
Top Products
25
Chapter 3: Using the remote control
Using the remote control to
control your other devices
If you have a non-Toshiba device or a Toshiba device
that the remote control is not preprogrammed to
operate, you must first program the remote control to
recognize the device (if you have not already done so)
(- page 28).
To use your TV remote control to operate:
•Cable converter box or satellite receiver, set the MODE
SELECT switch to CABLE/SAT.
•DVD player or HTIB, set the MODE SELECT switch
to DVD.
•VCR, set the MODE SELECT switch to AUX.
Note: Even after the TV remote control is programmed, it
may not operate certain features on any other devices. If
this happens and you wish to use those features, you will
need to use the device’s original remote control.
1 POWER Turns the selected device on and off.
2 Channel Numbers (0-9) Press to directly access
channels (as opposed to < ,).
3 +10 Press to directly access DVD chapters higher
than 10.
4 TOP MENU Accesses a DVD’s top menu.
5 CH Bb For channels programmed into the channel
memory (- page 35):
B selects the next higher channel.
b selects the next lower channel.
6 DVD RTN Returns to previous DVD’s menu.
7 INFO Displays TV status information on-screen.
8 BbC c Press to navigate DVD menus (may not
work on some DVD players).
9 OK Required by some satellite receivers and DVD
players to activate certain functions.
10 EXIT Closes on-screen menus.
DVD CLEAR Press to reset the title and chapter
number.
11 PLAY Begins playback of a tape or DVD.
12 PAUSE Press during play or record mode to pause
the picture; press again to restart.
13 STOP Stops the tape or DVD.
14 SKIP z Skips forward to locate later DVD
chapters.
15 FF Fast-forwards the tape or DVD. (Press during
play mode to view the picture moving rapidly
forward.)
16 SKIP Z Skips back to beginning of current DVD
chapter, or locates previous chapters.
17 REW Rewinds/reverses the tape or DVD. (Press
during play mode to view the picture moving
rapidly backward.)
18 MENU Accesses the menu in CABLE/SAT mode.
DVD MENU Accesses the DVD menu in DVD
mode.
19 GUIDE Displays the channel guide in CABLE/SAT
mode.
SET UP
Accesses a DVD’s setup menu in AUX
mode
.
20 SUBTITLE Accesses subtitles if available.
21 AUDIO Accesses the Audio menu.
22 MODE SELECT
S
witches set to “TV” to control the
TV; “CABLE/SAT” to control a cable converter box
or satellite receiver; “DVD” to control a DVD
player, HTIB or BD; “AUX” to control a VCR.
16
17
19
18
Point the remote control
directly at the device.