Filter
Top Products
53
Chapter 6: Basic features
Displaying TV status information
To display TV status information:
Press .
The following information will display (if applicable):
•Current input (ANT/CABLE, Video, etc.)
•If ANT/CABLE is the current input, either “CABLE”
(for cable TV) or “ANT” (for over-the-air broadcasts).
•Channel number (if in ANT/CABLE mode)
•Input label (if set)
•Digital signal strength indicator (bar graph in lower
right corner of box; for ATSC signal only)
•Stereo, Mono or SAP audio status (when HDMI input
mode, Dolby Digital or PCM)
•Video resolution
•Aspect ratio of incoming video signal (4:3 or 16:9)
•V-Chip rating status
•GameTimer (if set)
To close the screen:
Press again.
The following additional information (only available
for ANT/CABLE input) will display for off air digital
channels (if applicable):
•Title
•Duration
•Detailed description
To display next program information for digital
channels, press again. Pressing a third time will
remove the entire banner.
Note: The location of the banner can be moved to the top
or bottom of the screen by pressing B or b while the INFO
display is on-screen. The last position will be stored to
memory.
Viewing support information
1 From the SETUP menu, highlight System
Information.
2 Press to display support information containing
Web/Customer service numbers for US, Canada
and Mexico.
Reset Factory Defaults
You can reset all settings and channels to their factory
default values.
1 From the SETUP menu, highlight Reset TV and
press .
2 Enter your PIN code (if PIN code has been set).
3 Press C or c to select Yes and press . The TV will
turn off automatically.
To cancel the reset:
Press C or c to select No and press .
Understanding the auto power off
feature
The TV will automatically turn itself off after
approximately 15 minutes if it is tuned to a vacant
channel or a station that completes its broadcast for the
day.
Note:
• If you want to set this feature to off, see “No Signal Power
Down” on page 52.
• If it is possible that you will be away from the TV for an
extended period of time, you should unplug the power
cord.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the TV,
the Last Mode Memory feature automatically turns on
the TV when the power is resupplied.
INFOINFO
INFO
INFO
INFO
2-2
ANT
Nashville WX Channel
Nashville WX Channel provides Middle Tenessee and Southern Kentucky
weather
8:59am - 4:59pm EST
480i
4:3
NONE
OK
OK
OK
OK