Filter
Top Products
20
Using the TV’s features (General)
Adjusting the basic picture quality
1 In Digital TV, press
,
M then press Y or Z to display the
TV set up then press Q.
2 Press Y or Z to display the PICTURE menu.
3 In Analog TV, press M and Y or Z to display the
PICTURE menu.
4 Press V or U to select the Picture settings menu, then
press Q.
5 Press V or U to select an item you want to adjust, then
press Y or Z to adjust the settings as required.
Notes:
• The Tint may only be adjusted on NTSC signal.
• In the PC input mode (- page 25), Color, Tint and
Sharpness modes are not available.
Activating the black stretch
This function increases the strength of dark areas of the picture
which improves definition.
1 From the Picture settings menu, press V or U to
select Black stretch on the 2nd page.
2 Press Y or Z to select On or Off.
Note:
In the PC input mode (- page 25), this mode is not available.
Activating the MPEG NR (Noise Reduction)
If the receiving signal of MPEG is a mosquito (grained) noise
depending on the compression and conversion, the noise may
be reduced when using this function.
1 From the Picture settings menu, press V or U to
select MPEG NR on the 2nd page.
2 Press Y or Z to select Off, Low, Middle or High.
Note:
In the PC input mode (- page 25), this mode is not available.
Activating the DNR (Digital Noise
Reduction)
- analog only -
If the receiving signal is weak and the picture is blurry, the
picture may be improved when using this function.
1 From the Picture settings menu, press V or U to
select DNR on the 2nd page.
2 Press Y or Z to select Auto, Off, Low, Middle or High.
Selecting the color temperature
You can change the tone of the picture by selecting from three
preset color temperatures: Cool, Normal or Warm.
1 From the Picture settings menu, press V or U to
select Color Temperature on the 2nd page.
2 Press Y or Z to select mode you prefer.
Cool: Lends a blue hue to the picture.
Normal: Neutral
Warm: Lends a red hue to the picture.
Adjusting the color management
You can adjust the picture color quality by selecting from 6
base color adjustments : Red, Green, Blue, Yellow,
Magenta or Cyan.
1 Press M, then press Y or Z to display the PICTURE
menu.
2 Press V or U to select 3D Color management, then
press Y or Z to select On.
3 Press V or U to select Base color adjustment.
4 Press Q, then press V or U to select an item you want
to adjust.
Selection Y
Pressing
Z
Back light darker brighter
Contrast lower higher
Brightness darker brighter
Color paler deeper
Tint reddish greenish
Sharpness softer sharper
PICTURE
MENU
Back Watch TV
EXIT
OK
Picture settings
Off
Base color adjustment
3D Color management
Active Backlight Control
On
Cinema mode
On
Tint
Color
Back light
MENU
BackWatch TV
EXIT
100
50
0
0
Sharpness
Contrast
100
Picture settings 1/2
Brightness
50
Contrast 100
Color Temperature
Black stretch
MENU
Back Watch TV
EXIT
On
Cool
MPEG NR
Low
Picture settings 2/2
DNR
Auto
Black stretch
On
MPEG NR
High
DNR
Auto
Color Temperature
Cool
3D Color management
On
Hue
MENU
BackWatch TV
EXIT
Red
Blue
Green
Yellow
Magenta
Cyan
Saturation Brightness
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Reset
OK
Base color adjustment