Filter
Top Products
114
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 56/62/72MX195
Chapter 12: Troubleshooting
Symptom Solution
Recording problems • If you use the TV’s remote control to start recording, you will not be able to change inputs (page 67),
open the POP window (page 76), or open the FAV SCAN multi-window (page 78). If you attempt to do
so, the message “Not Available While Recording” will appear on-screen.
• If you are recording a digital channel, you will only be able to change analog channels while the recording
is in progress. If you are recording an analog channel, you will only be able to change digital channels
while the recording is in progress. This is because the TV tuner that is being recorded (digital or analog)
will be locked on the channel that is currently recording.
• It is recommended that you use the TV’s remote control to start recording. If you use a device other than
the TV’s remote control to start recording and then attempt to access a feature that is normally denied
during recording (POP mode, FAV SCAN mode, changing inputs,) the recorded audio and/or video may
not be what you intended to record. See pages 67 and 71.
•If
you connected a Symbio™ AVHD recorder, in order to use its full functionality, you must first set up the
TV Guide On Screen™ system (page 23 and Chapter 5).
Other problems • If your TV’s problem has not been addressed in this Troubleshooting section or the recommended
solution has not worked, use the Restore Factory Defaults procedure as described on page 52.
TV stops responding to controls • If the TV stops responding to the controls on the remote control or TV side panel buttons and you cannot
turn off the TV, press and hold the POWER button on the TV front panel for 5 or more seconds to reset
the TV.
Cannot connect to network. • Check modem and splitter connections.
• Make sure the splitter is connected to the modem or TEL.
• Confirm modem’s operation with this manual.
• Make sure your network address or E-mail account are set correctly (page xx).
Disable network connection • Check the LAN cable connection.
• Check that the modem’s power cord is plugged in.
• Make sure your network address or E-mail account are set correctly (page xx).
Unstable network connection. • Unplug the LAN cable from an outlet, and then connect again.
Cannot set recording timer by E-mail. • Select “Test” to confirm the setup( page xx).
• Select “Done” after setting up( page xx).
• See Chapter 11 in this manual.
#01E_112-118_566272MX195 05.7.11, 9:35 PM114
Black
Downloaded from www.Manualslib.com manuals search engine