Filter
Top Products
Toshiba TRR
4/00, Tecra
Page 19
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
To remove the display mask, follow the steps
below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack.
3. Remove two rubber seals at the
bottom corners of the display assembly.
4. Remove two M2.5x6 screws that were
covered by the rubber seals.
NOTE: Support the display with your hand
when you remove the screws.
5. Using the fingers of both hands,
carefully release the 18 latches along
the edges of the display mask. Begin
at the top (six latches), continue along
the sides (four latches on each side)
and the bottom (four latches).
í
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack and the
display mask.
3. Lay the display panel on its back.
4. Remove two M2.5x6 screws securing
the FL inverter board.
5. Lift up the FL inverter board and
disconnect the FL cable.
6. Rotate out the top end of the FL
inverter board. Disconnect the FL
inverter cable and lift out the FL
inverter board.
To remove the FL inverter board, follow the steps
below.
î