Filter
Top Products
Toshiba TRR
4/00, Tecra
Page 9
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
1. To install the cover, first remove the
SelectBay module then hold the cover
by the two finger grips and push it into
place until you hear the latches click.
2. To remove the cover, grasp the two
finger grips and pull the cover out.
You can use the SelectBay cover when you do
not need to use a SelectBay module.
1. Remove six M2x3 silver screws and
two M2.5x6 silver screws securing the
frame to the DVD-ROM drive.
2. Remove the connector cover.
3. Remove the metal frame, connector
board, and disconnect the flexible
cable.
To disassemble the DVD-ROM drive, follow the
steps below.
1. Remove six M2x6 silver screws.
2. Turn the FDD over and release two
latches securing the upper plastic
frame and lower plastic frame. Turn it
back over and lift off the cover.
3. Lift off the upper shield cover, unseat
the flexible cable connector from the
lower plastic frame, then lift out the
FDD.
4. Pull the flexible cable out of the FDD
connector.
5. Remove four M2x3 silver screws and
remove the FDD from the bracket.
To disassemble the FDD, follow the steps below.
î
ê
è