Filter
Top Products
4/00, TecraToshiba TRR Page 10
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
1. Seat the FDD in the bracket and
secure the bracket with four M2x3
silver screws. Tighten screws to a
torque of less than 2.2 kgfcm.
2. Insert the flexible cable into the
connector. Press gently to assure a
firm connection.
3. Seat the FDD in the lower plastic
frame and set the upper shield cover
in place.
4. Seat the flexible cable connector into
the lower plastic frame.
5. Set the upper plastic frame in place,
snap the two latches closed and secure
six M2x6 silver screws.
To assemble the FDD, follow the steps below.
CAUTION: Be very careful not to press on
the top or bottom of the HDD. Pressure can
destroy data or damage the drive.
To remove the HDD pack, follow the steps below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack.
3. Turn the computer upside down.
4. Slide the HDD cover to the right and
push the HDD pack forward until the
back edge is aligned with a marker next
to the HDD slot.
5. Lift up on the cover to remove the HDD
pack.
To disassemble the HDD Pack, follow the steps
below.
1. Slide the cover firmly in the direction of
the arrow and remove it.
2. Remove the HDD tray and connector
cover.
í
Images / text continued on the next page
î