Filter
Top Products
4/00, TecraToshiba TRR Page 12
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
To install the HDD pack, follow the steps below.
1. Align the HDD pack with the marker on
the computer and seat the HDD so that
tabs on the HDD fit into notches on the
computer.
2. Make sure the cover is pushed fully to
the right and push the HDD back to
ensure a firm connection.
3. Slide the cover to the left to lock the
HDD into the slot.
4. Install the battery pack.
To remove the memory module(s), make sure the
computer is in boot mode and follow the steps
below.
CAUTION: Do not try to remove a memory
module(s) with the computer turned on. You
can damage the computer and the memory
module(s).
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack and HDD pack.
3. Lift up the mylar cover.
4. Use a slender object (plastic card) to
press the latches on either side of the
memory module(s) to the outside and
the memory module will pop up.
5. Grasp the memory module(s) by the
sides and pull it out.
CAUTION: Do not touch the connectors on
the memory module(s) or on the computer.
Debris on the connectors may cause memory
access problems.
The modem board is located under the palmrest.
To open the palmrest, follow the steps below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack, optional PC
card, and HDD pack.
3. With the computer still upside down,
remove two M2x8 silver screws, two
M2x22 silver screws and two M2x14
silver screws.
4. Turn the computer right side up and
open the display panel and PC card
cover.
5. Grasp the sides of the palmrest and pull
it forward until tabs on either side clear
the holes on the top cover. Three
latches are located under the palmrest
as shown below.
6. Carefully lift the palmrest.
Images / text continued on the next page
î
î