Filter
Top Products
4/00, TecraToshiba TRR Page 8
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
To remove the optional PC card, make sure the
computer is in boot mode, then follow the steps
below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack.
3. Open or remove the PC card slot cover.
4. Press in slightly on the eject button for
the upper and/or lower card and the
button will pop out fully.
5. Now, press the button firmly to pop the
PC card out partially.
6. Grasp the PC card and remove it.
7. Close or replace the PC card slot cover.
To install the PC card, follow the steps below.
1. Open or remove the PC card slot cover.
2. Insert the PC card and press gently to
ensure a firm connection.
3. Close the slot cover or replace the
cover with an appropriate one.
4. Install the battery pack.
To remove the SelectBay module, follow the
steps below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack.
3. Turn the computer upside down and
slide the SelectBay lock to the unlock
position, shown by a red box.
4. Pull out the release lever.
5. Push the release lever in firmly to pop
the SelectBay module partially out of
the bay.
6. Grasp the module and pull it out.
CAUTION: The SelectBay modules can
become hot with use.
Be careful when removing the module.
1. Insert the module in the computer and
press until it locks into place.
2. Fold the release lever into the closed
position.
3. Slide the SelectBay lock to the locked
position. The red box should not be
visible.
4. Install the battery pack.
Install the SelectBay modules as described
below.