Filter
Top Products
English
- 9
Connections
Connecting DVD-VCR
to the TV using the
RF Cable
To receive television programmes a signal must be
received from one of the following sources:
• An outdoor aerial
• An indoor aerial
• A cable television network
• A satellite receiver
1
Remove the aerial or network input cable from
the television.
2
Connect this cable to the 75Ω coaxial jack
marked on the rear of your DVD-VCR.
3
Plug the RF Cable supplied into , the jack
on your DVD-VCR.
4
Plug the other end of the RF Cable into the
connector previously used for the aerial on the
television.
TV
Make sure that both the television and the
DVD-VCR are switched off before
connecting the cables.
Note
TV
RF cable
Aerial cable
Aerial
2
3
4
Connecting DVD-VCR
to the TV using the
SCART Cable
You can connect your DVD-VCR to the television
using the SCART cable if the appropriate input is
available on the television. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your DVD-VCR
1
Connect the Aerial Cable.
2
Connect one end of the SCART cable to the AV1
(EURO AV) jack on the rear of the DVD-VCR.
3
Plug the other end into the appropriate
connector on the television.
❚
Connecting the Audio Output Cable
You can connect your DVD-VCR to a Hi-Fi system.
Example:You wish to take advantage of the quality of
your Hi-Fi stereo system when watching a
disc play.
4
Plug the audio output cable into the audio
connectors on the rear of your DVD-VCR.
5
Plug the other end of the audio cable into the
appropriate input connectors on your Hi-Fi
stereo system.
4
2
TV
RF cable
Aerial
3
1
5
Regardless of the type of connection chosen,
you must always connect the RF Cable
supplied. Otherwise, no picture will be visible on
the screen when the DVD-VCR is switched off.
Make sure that both the television and the
DVD-VCR are switched off before connecting
the cables.
Note
SCART Cable
(not supplied)