Filter
Top Products
24
Chapter 2: Connecting your TV
62HM15
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Connecting IEEE1394 video devices (continued)
Important information regarding
IEEE1394 device interconnection
Note:
• Do not loop the last device in the chain back to the TV.
If the device chain is looped, the TV may not work properly with the
other devices in the chain.
• Place devices with the slowest communication speed at
the end of each chain. If a device with a slower communication
speed is placed ahead of a faster device in the chain, the signal
from the slower device will interfere with the signal from the faster
device. To determine the communication speed of an IEEE1394
device, look for an “S” number near the device’s IEEE1394
connector. The higher the “S” number, the faster the device. If your
device is not marked with an “S” number, look in the device’s user
manual or call the device manufacturer’s technical support number.
• If your IEEE1394 device has a two-position power
switch, place the device at the end of the chain
otherwise, If the power switch is OFF, it will interfere with signals
from devices behind it in the chain.
• The maximum length for an IEEE1394 cable between
each device is 15 feet.
•This TV is an IEEE1394A device. The IEEE1394B protocol is faster
and intended to allow for longer distances between devices and
multi-room systems. IEEE1394A–to–IEEE1394B converters
(available at some electronics suppliers) may allow compatibility of
IEEE1394B devices with your existing IEEE1394A devices.
•The transmission capability of IEEE1394 cable used with this TV
must be S400 (400 Mbps maximum).
IEEE1394 device management
The IEEE1394 device information is saved in the TV’s memory.
You can edit this device information (for example, to edit the
device name, change the analog input information, or delete the
device information from the TV’s memory if you no longer use
that device).
To edit the IEEE1394 device information:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below).
3. Open the DEVICES menu, highlight IEEE1394
DEVICES, and press ENTER.
Devices
IEE-1394 Devices
TheaterNet Devices
Navigate Select Back Exit
DVD RTN
CH RTN
EXIT
4. Highlight the device you want to edit and press ENTER.
5. Follow the on-screen prompts to modify the device
information.
#01E012-025_62HM15 5/24/05, 6:17 PM24
Black