Filter
Top Products
67
62HM15
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
You can label each video input source according to the type of
device you connected to each source, from the following preset
list of labels:
– – (default label)
Hide (to hide an unused input in the Input Selection window)
Audio Receiver
VCR
Video Recorder
Laser Disk
Compact Disc
DVD
DTV
Satellite/DSS
Cable
Note:
• If you set up devices in TheaterNet™, the associated inputs are
automatically labeled and cannot be relabeled until you remove
the device from TheaterNet (see page 44).
• If you set up a cable box in VIDEO 1, that input will be labeled
automatically and cannot be relabeled until you remove the device
from the TV Guide On Screen
®
setup.
•You cannot select IEEE1394 devices through the INPUT SELECTION
window; however, you can select and control IEEE1394 devices through
TheaterNet (see page 44).
To label the video input sources:
1. Press MENU and open the PREFERENCES menu.
2. Highlight INPUT LABELING and press ENTER.
3. Press z or y to highlight the video source you want to
label.
Save Cancel
Video 1Video 1
Video 3
Video 2
Input Labeling
--
--
VCR
Color Stream HD 1
HDMI
Color Stream HD 2
ANT 2
--
--
--
--
Reset
4. Press x or • to select the desired label for that input source.
If a particular input is not used, you can select “HIDDEN”
as the label, which will cause that input to be “grayed out”
in the input list and skipped over when you press the
INPUT button on the remote control.
Note: If you select “HIDDEN” for all of the input labels, the
POP feature will be disabled. If you then attempt to access the
POP feature, the message “Not available” will appear on-screen.
5. To save the new input labels, highlight SAVE and press
ENTER.
To revert to the factory default labels, highlight RESET
and press ENTER.
Chapter 8: Using the TV’s features
Input labeling example:
The screen below left shows the default Input Selection screen
(with none of the inputs labeled). The screen below right is an
example of how you could label the inputs if you had connected
a VCR to VIDEO 1, a DVD player to ColorStream HD1, a
high definition satellite receiver to HDMI. Also note that the
ColorStream HD2 input is labeled “Hidden,” which means that
the input will be skipped over when INPUT or TV/VIDEO is
pressed.
Input Selection screen Input Selection screen with
with no inputs labeled inputs 1, 4, and 6 labeled,
and input 5 hidden.
To clear the input labels:
1. Press MENU and open the PREFERENCES menu.
2. Highlight INPUT LABELING and press ENTER.
3. Highlight RESET and press ENTER.
4. Highlight SAVE and press ENTER.
Save Cancel
Video 1Video 1
Video 3
Video 2
Input Labeling
--
--
VCR
Color Stream HD 1
HDMI
Color Stream HD 2
ANT 2
--
--
--
--
Reset
NOTE: If you set up a device in TheaterNet, its input label will
not be cleared unless you remove the device from TheaterNet
(see page 44). The screen above right illustrates an example
of the Input Labeling screen after it was reset that still shows
the VCR label for VIDEO 1 because the VCR was set up in
TheaterNet.
Labeling the video input sources
#01E066-075_62HM15 5/24/05, 6:20 PM67
Black