Filter
Top Products
PROGRAMMING VCR/DVD CONTROL
Locate the brand name of your VCR/DVD in the
Setup Codes For VCRs and DVD section below, and
write it in the following space.
VCR Brand: _________________________________
The brands are listed in alphabetical order with the
most popular codes listed first. You will use one of
these codes to program the Millennium 4 to oper-
ate your VCR:
1. Turn on your VCR or DVD.
2. On the Millennium 4, press VCR once.
Press and hold SETUP until the LED
blinks twice, then release SETUP.
3. Enter the first four-digit code for your
VCR. If you perform this procedure cor-
rectly, the LED will blink twice.
NOTE: If the LED did not blink twice after
entering the code’s last digit, then repeat steps 2
through 3 and try entering the same code again.
4.
Aim the Millennium 4 at your VCR and
press POWER once. The VCR should turn
off. If your VCR remote control does not
have a POWER key, press PLAY. If the
VCR does not respond, repeat steps 2-3,
trying each code listed for your brand
until you find one that works. If the VCR
still does not work , try searching for the
code (see Searching For Your Code on
page 38).
5. Write your VCR code in the boxes below
for future reference.
NOTE: Remember, to use the Millennium 4 to operate
your VCR, or DVD press VCR first.
Setup Codes for VCRs:
ABS 1972
Admiral 0048, 0209
Adventura 0000
Aiko 0278 continued on next page..
Setup Codes for VCRs (continued):
Headquarter 0046
Hewlett Packard 1972
18