Filter
Top Products
CHECKING THE CODES
If you have set up the Millennium 4 using the
Searching For Your Code procedure, you may need
to find out which four-digit code is operating your
equipment:
For example, to find out which code is operating
your TV:
1. Turn on your TV.
2.
On the Millennium 4, press and hold
SETUP until the LED blinks twice, then
release SETUP.
3. Enter 9 - 9 - 0. The LED will blink twice.
4.
To view the code for the first digit, press
1 once. Wait 3 seconds and count the
number of LED blinks (e.g., 3 blinks =-3)
and write down the number in the left-
most TV Code box below.
NOTE: If a code digit is “0”, the LED will not
blink.
5. Repeat step 4 three more times for
remainingdigits. Use 2 for the second
digit, 3 for the third digit, and 4 for the
fourth digit. Finish writing down the
code in the TV Code boxes below.
6. To check for the codes of your other
components, repeat steps 1 through 5,
but substitute the appropriate key (i.e.,
VCR or AUDIO) for the (VCR, or Audio)
component you are checking. Write
down the codes in the appropriate boxes
below.
TV Code
VCR Code
39