Filter
Top Products
TROUBLESHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM: LED blinks when you press a key, but
home entertainment component does not
respond.
SOLUTION: Make sure you are aiming the Millennium
4 at your home entertainment component
and that you are within 15-feet of the com-
ponent you are
trying to control.
PROBLEM: The Millennium 4 does not control home
entertainment components or commands
are not performing properly.
SOLUTION: Try all listed codes for the component
brand being set up. Make sure all
components can be operated with an infra
red remote control.
PROBLEM: TV/VCR combo does not respond prop-
erly.
SOLUTION: Use the VCR codes for your brand.
Some combo units may require both a TV
code and a VCRcode for full operation
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume
Lock.
PROBLEM: CH+ , CH– , and LAST do not work for
your RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the
originalremote control will operate these
functions.
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing
ENTER to change channels, press ENTER
on the Millennium 4 after entering a chan
nel number.
PROBLEM: Tried “Search Method” and still could not
find a working code.
SOLUTION: Try the “Search Method” again after clear-
ing out the device key as follows: Press and
hold ENTER until red light blinks twice,
then release. Next enter 9 - 9 - 2. Then
press and release the device
43